Inverter 999hz power

Which air switch should be used in front of the inverter?

Air switch should be used as the over-current protection device in front of the inverter power. If there is LCDI, and it is afraid of breakdown, please choose the LCDI whose sensitivity level is above 200mA and reaction period last more than 100ms. In order to reduce the leakage of current, the connection wire should not be over 50 meters.

What is t/stop3 inverter frequency setting mode?

t/Stop3 Inverter Frequency Setting ModeThe invert r frequency setting mode is set by F0.03. When F0.03 = 0, the unning frequency is set by potentiometer. When F0.03 = 3, the running frequency is input by AVI (0-10V can be connected with potentiometer); when F0.03 = 5, the r

How to set the inverter Fwd / rev mode?

When you use the panel to control the inverter, you should remember that clicking the green button means start the inverter and clicking the red button means stop. Before any operation, the inverter defaults to start FWD. FWD and REV are set by input terminal S1-S5. (the REV set is 4) The inverter frequency setting mode is set by F0.03.

How to set a multistage inverter?

The inverter should be connected with the ground well. Set according to parameter F2.13, and factory set defaults tobe FWD. Set according to parameter F2.15, and factory set defaults tobe the first one of multistage speed. Set according to parameter F2.17, and factory set defaults tobe external RST. Select the parameter d-00, and click SET.

What should I know before using the inverter?

arationThanks for choosing the inverter. Before you use it, please read the instructions carefully, and making sure that you h the safety precaution.Safety Precaution:Before wring, ple e make sure that the input power is off.The wring work should be operate by the professional electrical engineer.The grounding te

What to do if the inverter ices?

ice, or the inverter may start suddenly.Do not touch the terminals of inverter, which are very danger s because there is high voltage on them.When power is , do not change the wiring and terminal.Cut off the main circuit power fore doing some check and maintain work